Home Improvement

DIY Project: Step By Step Guide On How To Make A Cube Wine Rack for Beginners

A wine rack is a straightforward project to add a contemporary look to your kitchen. In addition, it gives a terrific spot to store your wine and is more eye-catching than a regular wine rack, making it ideal for a modern kitchen.

Moreover, a cube wine rack is an attractive storage option that is a lovely weekend plan to build yourself. It is usually not expensive, and it is a straightforward process that takes little equipment and woodworking expertise.

Getting Started

Most cube wine racks can be made with a few essential woodworking tools such as:

  • A Power Driller, 
  • Measuring Tape, 
  • Powered Circular Saw, 
  • And Router Blade. 

Depending on the complexity of the project, more information may be included.

  1. Select a Crate– You can use a wooden box to create the cube in your wine rack. Plastic crates work fine; however, a wood crate will look better and be more solid. 

Choose a crate that is at least 12 inches tall and 18 inches broad for your project. You’ll be able to keep a good quantity of wine bottles due to this. 

It should also be around 10 to 12 inches deep to fully accommodate and stabilize the bottles.

As with any wine rack, you should maintain the wine bottles on their sides, and this keeps the corks moist and makes them easy to remove with a corkscrew. After you’ve decided on a crate, paint it to match the colors in your kitchen.

A primer and two layers of gloss paint will provide maximum protection for the wood as the bottles slide in and out of the racks.

  1. Trim and Cut- To turn your cube into a wine rack, you’ll need a piece of wood that cuts through the inside of the cube on the diagonal from bottom left to top right or bottom right to bottom left. 

Take measurements of the depth of your crate as well as the distance along your diagonal. 

Make a template for this on a piece of plywood that is at least 1/8 inch thick to efficiently support the bottles in the cube rack.

Ensure that the plywood fits well and tight into the cube rack before removing it. It would be best to paint the plywood before the final assembly.

You can either use the same color as the rest of the rack or a contrasting color to add a pop of color. Next, paint both sides of the plywood and the edge that will face into the room, and allow it to dry completely.

  1. Finish the Wine Rack- Apply glue to the plywood’s borders and back. These are the edges of the box that will make contact with the wood. Now, on the diagonal, press the plywood in. 

This procedure works best if the crate is on the floor, open side up. Then, firmly press down on the plywood to ensure it is secured in place. 

Wipe away any excess glue before securing it with a weight on the top. To have a finished cube rack, wait till the glue dries.


While making this DIY Project keep in mind to wear your safety goggles, ensure your working area is clean, and always handle your equipment with precaution to avoid serious injuries.

For more valuable information visit this website

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button